Jun 30, 2014

Jun 29, 2014

First contact on 6m

Hi all

The high band condition goes up today. At the noon, the started Es propagation in domestic area.
 
I tried CQ on 50.330Mhz. That frequency can used JA domestic QSO. As not same DX QSO frequency.
 
At the few times called CQ then return to answer. I QSO for total 2 stations.

I am very happy, not DX but my first QSO on 6m JT65 mode.

Next I will try to DX.

So everyone see you on 6m.

Jun 25, 2014

Outside of frequency width

Hi all
 
This morning I found the DX station on 30m JT65 mode.
 
That DX station QRV on 249Hz. This mean that USB mode can used JT65 mode. So Transceiver indicated carrier point frequency. Normally 10138.00KHz.
 
That 249Hz mean is JT65 signal frequency. Normally SSB signal band width as same as voice frequency width. Therefore 300Hz to 3000Hz is standard frequency width.

However, that DX station used 249Hz that it value is out of voice frequency width. So it cannot send JT65 signal.
 
However, I used IC-7700 transceiver. This transceiver set the transmitted frequency width. Because this transceiver used DSP system. So easy setup TX or RX frequency range.
 
Therefore I set up on 100Hz for lower transmitter frequency of my IC-7700.
I QSO for that DX station.
 
I think, the popular transceiver cannot change the TX frequency range. It fix to 350Hz to 2700Hz. Therefore normally cannot use under 350Hz frequency, I think so.
 
What do you think? Correct or not. 
 

Jun 22, 2014

eQSL Collection SV6JHA

Hi all

Now I have 30m antenna only. So I QRV on JT65 mode on 30m only.
This is this morning QSO, Thanks Chris.


Jun 19, 2014

eQSL Collection XE2YWH

Hi all

Recently I was QSO on 30m band. Thanks nice QSO.


Jun 18, 2014

eQSL Collection IT9BYL

Hi all

Many thanks nice QSO for all.

A dirty signal

Hi all

After a long time, I found a dirty signal on 30m band.

Signal picture as follows.
The signal appearance was very wide span and over modulation. 
Maybe he don't know that dirty signal send by himself.

He forgot speech comp turn off.



Jun 17, 2014

Time not to be audible

Hi all

Everyday morning, I heard on 30m. I found one matter. That is not audible time
 
That mean, before 1 minute I heard DX signal. However after 1 minute, I cannot heard DX signal, it 's everything.
 
This situation keep about 30 minutes.  In the meantime, nothing can be heard.
 
After 30 minutes the DX signal return again.
 
I usual heard time as same not be audible time. Therefore I cannot QSO that time.
 
So my activity to down now.

Jun 16, 2014

30m situation

Hi all

The antenna of the high band was removed in the beginning this month next month for transfer. Therefore, the antenna of HF held now is only a 30m band.
 
Recently I heard JT65 mode only 30m. The 30m is low activity compare high band. 

There is no condition well. However, I always QRV someone every day. This morning here also, R5 station only QRV this morning here. He called CQ many times. I called him and QSO.

After that, many Europe station calling CQ.  I think, almost station can check for the band condition. If who start QSO then where place open now? 
 
Actually the band condition is not so good. But I got 5 new stations on JT65 mode.  I think it is great!

On CW mode, almost not hear DX station on the band. But JT65 is different. It is always QRV some. JT65 It is proof that the mode became major.


eQSL Collection M6DHV

Hi all

I change posting title. Before arrived eQSL that it is introduce for new eQSL. But I change the eQSL collection that it is introduce for my eQSL collection.

Many thanks nice QSO for all.


Jun 13, 2014

Need PC clock Adj

Hi all

This morning, I was operated on 30m band. And I found not so good signal. As follows no good signal picture.


The center was called signal for me. That problem signal was left side signal.
 
That signal started before 00 second by each minutes. Therefore receiving station cannot decode this signal.
 
This station cannot QSO forever.
 
Sometimes I found these signal on the band. PC clock adjustment action is basic standard for the JT65 operation.
 
Especially if you can used old PC then you must check PC clock before JT65 operation.
 

Jun 11, 2014

It is as good as except

Hi all

This morning, I was watched on 30m band. The solar activity is very high level.

The SSN and SFI was over 150. So the band is very noisy. Therefor I cannot found DX station on CW mode.
 
However, JT65 was different. I found a few DX stations on JT65 mode band.
 
There are European stations. I, UR, YO stations. Especially I station was very active. I found also JT9 mode.
 
CW band was quiet, but JT65 band was not as same.
 
All stations coming -10 to -18dB signal. I called CQ one time. Then OZ station return to me that it was -20dB signal.
 
Between Europe and Japan, the path certainly exists. However, unless the station which QRV is the band, everyone don't know now open or not.

Jun 7, 2014

An unpleasant SWL report

Hi all

Is it operating by JT65 mode ?
 
Now, there is subject of an unpleasant SWL report between JA.
 
That is not write RST, QSO station call. And that reports send a few report each 10 minutes by 1day.  And continue 2 days report. So totally nearly 10 same reports. 
 
What is different? Only day and time is different. This report from Taiwan.
 
Many JA stations received this SWL reports. 
 
Every JA said. It is an unpleasant. If it write all detail date that it is welcome SWL report. However, no have detail data. No thanks. 
 
What do you think? 
 
eQSL does not Upload purposely for the honor of the station which I have sent.
 

Arrived eQSL TA/IZ5KID

HI all

Is it operating by JT65 mode?

I received new eQSL. Thanks QSO.


Jun 5, 2014

Arrived eQSL TA1BM

Hi all

Is it operating by JT65 mode?

I received new eQSL. Thanks QSO.


Jun 4, 2014

North Pole opend

Hi all 

Is it operating by JT65 mode?
 
Last night here, solar activity report was no good. SSN value was still low.
 
However, at 2000 to 2100 local time, it same as 1100z to 1200z.
 
The band activity go up. Some station used same frequency. So no decode happen with QRM.
 
I called CQ, then it continued being called for 30 minutes from the Europe.
 
After that, I watch the band. I found the TF call. It was good for signal that it about -4dB. 
 
TF signal found a after long time on the band. 
 
Really it was good condition on 15m. I checked other band that there were so so. The best was 15m band.

Jun 3, 2014

Jun 2, 2014

The 15m condition

Hi all

Last night I tried JT65 mode on 15m band. Before I checked on 20m. The 20m band condition was not so good. It was unstable.

However, the 15m was big different compare the 20m. It had many stations signal. Almost signal came from the Europe.


I called few stations. Good signal came here, but sometimes no return.  As same as one way path. 
 
Maybe signal drop point was not mutch. So signal was strong but as same one way situation.
 
Everyday on 15m is good, but 20m is no good. When it improve the condition on 20m?
 

Jun 1, 2014

Great open on 15m

Hi all
 
Last night, on 15m was good open for the European path from JA.
 
It was wonderful situation. Many European stations signal came here. If arrived signal level was very low, never mind. Also noise floor was very low. I can copy weak signal.
 
About 1hour, I was contacted a lot of stations. It's really after a long time.
 
I wish to keep this good condition.